Eldom 72324PMP 7-Liter Under-Sink Pressure-Resistant Water Heater User Manual

1. Инструкции за безбедност

Please read these safety instructions carefully before installing, operating, or performing maintenance on the appliance. Failure to follow these instructions may result in electric shock, fire, property damage, or personal injury.

• Installation and electrical connections must be performed by qualified personnel in accordance with local regulations.
• Уверете се дека апаратот е правилно заземјен.
• Do not operate the water heater if the power cord or plug is damaged.
• Always ensure the water heater is filled with water before switching on the power.
• The pressure relief valve must be installed and maintained correctly to prevent excessive pressure build-up. Do not block or tamper со вентилот.
• Чувајте ги запаливите материјали подалеку од апаратот.
• Овој апарат е дизајниран само за внатрешна употреба.

2. Производот завршиview

The Eldom 72324PMP is a compact 7-liter under-sink electric water heater designed for pressure-resistant operation. It features a durable steel tank with high-performance enamel and additional anode protection against corrosion, ensuring a long service life. An integrated anti-return valve prevents backflow and protects against overpressure. The continuous temperature regulator allows precise control over water temperature.

Figure 1: Eldom 72324PMP 7-Liter Under-Sink Water Heater. This image shows the compact design suitable for under-sink installation.

Клучни карактеристики:

• Капацитет: 7 литри
• Тип на инсталација: Under-sink, pressure-resistant
• Материјал на резервоарот: Steel with high-performance enamel coating
• Заштита од корозија: Anode protection system
• Безбедност: Integrated anti-return valve and safety valve
• Контрола на температурата: Continuous temperature regulator
• Моќност: 1500 W
• Енергетска ефикасност: Класа Б

3. Технички спецификации

Figure 2: Energy Label for Eldom 72324PMP, indicating Class B efficiency and 95 kWh/annum consumption.

За подетални информации за производот, погледнете ја базата на податоци EPREL: https://eprel.ec.europa.eu/qr/85466

4. Поставување

4.1 Поставување

• The water heater is designed for under-sink installation. Ensure there is sufficient space for the unit and its connections.
• Mount the unit securely to a solid surface, such as a wall, using appropriate fasteners. The unit is designed for wall mounting.
• Осигурајте се дека локацијата е заштитена од температури на мрзнење.

4.2 Приклучок за вода

Connect the water heater to the cold and hot water supply using 1/2 inch connections. It is crucial to install the supplied safety valve on the cold water inlet. This valve prevents excessive pressure build-up inside the tank.

1. Install the safety valve on the cold water inlet pipe. Ensure the arrow on the valve points towards the water heater.
2. Connect the cold water supply to the inlet of the safety valve.
3. Connect the hot water outlet of the water heater to the hot water tap.
4. Open the hot water tap to allow air to escape while the tank fills with water.
5. Once water flows steadily from the hot water tap, close the tap. Check all connections for leaks.

4.3 Електрично поврзување

The appliance comes with a power cable and plug. Ensure the electrical outlet is properly grounded and matches the voltage and frequency requirements (230V/50Hz).

• Before plugging in the appliance, ensure the water tank is completely filled.
• Вклучете го кабелот за напојување во соодветен заземјен електричен штекер.
• Не користете продолжни кабли или адаптери.

5. Работење

5.1 Почетно стартување

After installation and filling the tank with water, the unit is ready for operation.

1. Ensure the water heater is properly connected to both water and electricity.
2. Turn on the power supply to the unit. The indicator light (if present) should illuminate.
3. The water heater will begin heating the water to the set temperature. The initial heating cycle for 7 liters from 12°C to 65°C takes approximately 13 minutes.

5.2 Прилагодување на температурата

The water heater is equipped with a continuous temperature regulator, usually a dial or knob on the front or bottom of the unit.

• Rotate the temperature regulator to your desired setting. Higher settings will result in hotter water.
• Термостатот автоматски ќе ја одржува поставената температура.

6. Одржување

Редовното одржување обезбедува оптимални перформанси и го продолжува животниот век на вашиот бојлер. Секогаш исклучувајте го напојувањето пред да вршите какво било одржување.

6.1 Редовно чистење

• Исчистете ја надворешноста на единицата со мека, гamp крпа. Не користете абразивни средства за чистење или растворувачи.
• Periodically check the safety valve for proper operation. Refer to the safety valve manufacturer's instructions for testing.

6.2 Декалирање

Depending on water hardness, scale deposits may accumulate inside the tank and on the heating element, reducing efficiency. Descaling should be performed periodically by a qualified technician.

• Disconnect the power supply and drain the water heater.
• Access the heating element and tank interior to remove scale deposits.
• Replace the anode rod if it is significantly depleted, as it is crucial for corrosion protection.

7 Смена на проблеми

Пред да контактирате со корисничката поддршка, проверете ги следните вообичаени проблеми и решенија:

8. Гаранција и поддршка

This Eldom water heater is manufactured to high-quality standards. For warranty information, please refer to the documentation provided with your purchase or contact your retailer.

Контакт информации за производителот:

• Производител: Елдоминвест
• Webсајт: https://eldominvest.com/
• Е-пошта: tech@eldominvest.com
• Телефон: +359 52 571 914
• Адреса: Boulevard "Vladislav Varnenchik" 275A, 9009 Varna, Bulgaria