Вовед
Thank you for choosing the STEINEL HS 152 XENO Sensor Halogen Floodlight. This product is designed to provide efficient and reliable outdoor lighting with integrated motion detection for enhanced security and convenience. Please read this manual carefully to ensure proper installation, operation, and maintenance of your floodlight.
Image: STEINEL HS 152 XENO Sensor Halogen Floodlight. This image shows the floodlight from a front-side angle, highlighting its compact design and the integrated motion sensor below the lamp домување.
Инструкции за безбедност
WARNING: Risk of electric shock! Installation requires knowledge of electrical systems. Incorrect installation can lead to fire or electric shock. For your safety, always consult a qualified electrician if you have any doubts.
- Disconnect power at the main fuse or circuit breaker before installation or maintenance.
- Обезбедете снабдување voltage matches the floodlight's requirements (230-240V).
- Do not open the product housing unless specified in this manual.
- Не го менувајте производот на кој било начин.
- Чувајте ги децата подалеку од материјали за пакување.
- The floodlight becomes hot during operation. Avoid touching the lamp or housing immediately after use.
- Обезбедете правилно заземјување според локалните електрични прописи.
- This product is rated IP44 for protection against splashing water. Do not immerse in water.
Содржина на пакетот
Please check that all parts are present and undamaged:
- 1x STEINEL HS 152 XENO Sensor Halogen Floodlight (with integrated R7s 150W halogen lamp)
- 1x Set of mounting screws and wall plugs
- 1x Set of cover plates for detection range adjustment
- 1x Упатство за употреба
Инсталација
- Подготовка: Turn off the power supply at the main circuit breaker. Use a voltage tester to ensure the circuit is de-energized.
- Локација за монтирање: Choose a suitable mounting location, ideally 1.8m to 2.5m above the ground, where the sensor has an unobstructed view of the desired detection area. Avoid mounting near heat sources or objects that might cause false triggers (e.g., moving branches, busy roads).
- Дупчење: Mark the drilling points using the floodlight's mounting plate as a template. Drill holes and insert wall plugs.
- Жици: Connect the electrical wires (Live, Neutral, Earth) from your mains supply to the corresponding terminals inside the floodlight's wiring compartment. Ensure all connections are secure.
- Mounting the Floodlight: Secure the floodlight to the wall using the provided screws. Adjust the floodlight head to the desired angle.
- Вклучување: Restore power at the main circuit breaker. The floodlight will perform a brief self-test.
Операција
The STEINEL HS 152 XENO floodlight features an integrated passive infrared (PIR) motion sensor. When motion is detected within its adjustable range and the ambient light level falls below the set twilight threshold, the floodlight will automatically switch on for the pre-set duration.
Прилагодување на сензорот
The sensor has three main adjustment controls, typically located on the underside of the sensor head:
- Range (Reach): Adjusts the detection distance, up to 12 meters, limitable to approximately 5 meters using the included cover plates. Turn the dial to increase or decrease the range.
- Twilight Threshold (Lux): Sets the ambient light level at which the sensor becomes active. Turn towards the sun symbol for daylight operation (test mode) or towards the moon symbol for activation only in darkness.
- Time Setting (Time): Determines how long the light remains on after motion is detected. Adjust the dial to set the desired duration.
The detection angle is 180° with an opening angle of 90°. Use the provided cover plates to precisely mask out areas you do not wish to be detected, such as public pathways or neighboring properties.
Одржување
Чистење
Clean the floodlight and sensor lens regularly with a soft, damp cloth. Do not use abrasive cleaners or solvents, as these can damage the surfaces or the sensor lens.
Lamp Замена
WARNING: Disconnect power before replacing the lamp.
- Ensure the floodlight is cool before handling.
- Внимателно отворете го лamp домување.
- Remove the old R7s halogen lamp.
- Insert a new R7s 150W halogen lamp. Ensure it is correctly seated.
- Затворете го lamp housing securely.
- Вратете ја напојувањето.
Решавање проблеми
| Проблем | Можна причина | Решение |
|---|---|---|
| Светлото не се вклучува. | Нема напојување. Lamp неисправни. Twilight threshold set too high (daylight). Sensor range too low. | Проверете го прекинувачот. Заменете го lamp. Adjust twilight setting towards 'moon' symbol. Increase sensor range. |
| Светлината останува постојано вклучена. | Континуирано движење во зоната на детекција. Неисправен сензор. | Adjust sensor range or mask detection area. Контактирајте ја поддршката за корисници. |
| Light turns on without apparent motion. | False triggers (e.g., heat sources, small animals, moving branches). | Adjust sensor angle, reduce range, or use cover plates to mask problematic areas. |
Спецификации
| Бренд: | ШТАЈНЕЛ |
| Број на модел: | 632113 |
| Боја: | Црното (Note: Product title indicates 'ws' for white, but specifications list 'Noir' for black.) |
| Специјална карактеристика: | Детектор на движење |
| Материјал: | Стакло |
| Извор на енергија: | Електричен со кабел |
| Тип на извор на светлина: | Халоген |
| Број на извори на светлина: | 1 |
| Voltage: | 230 волти |
| Ватtage: | 150 вати |
| Класа на заштита: | IP44 |
| Агол на откривање: | 180° (Opening angle 90°) |
| Макс. Опсег на откривање: | 12 meters (adjustable to 5 meters) |
Гаранција и поддршка
For warranty information and technical support, please refer to the official STEINEL website or contact your local STEINEL distributor. Keep your purchase receipt as proof of purchase.
STEINEL Contact Information:
- Official STEINEL Webсајт
- Погледнете го пакувањето на производот за специфични контакти за регионална поддршка.
