1. Вовед
Thank you for choosing the Carbest 12V Water Pump. This manual provides essential information for the safe and efficient installation, operation, and maintenance of your pump. Please read this manual thoroughly before use and retain it for future reference.
This 12V pressure water pump features a robust construction designed for a long service life. It operates with a cut-off pressure of 2.8 bar and delivers a flow rate of 10 liters per minute. The pump incorporates a 3-compartment membrane system for reliable performance.
2. Инструкции за безбедност
- Always disconnect power before installing, servicing, or performing any maintenance on the pump.
- Ensure the power supply matches the pump's rated voltage (12V DC).
- Не работете со пумпата со запаливи течности. Оваа пумпа е дизајнирана само за вода.
- Заштитете ја пумпата од температури на мрзнење.
- Обезбедете соодветна вентилација околу пумпата за да спречите прегревање.
- Use appropriate wiring and fuses for the rated current (7.5A) to prevent electrical hazards.
- Install the pump in a dry location, protected from direct water spray.
3. Поставување и инсталација
3.1 Отпакување
Carefully remove the pump and all components from the packaging. Inspect for any damage that may have occurred during transit. Do not use if damaged.
3.2 Монтирање
Mount the pump in a secure, dry location. The pump can be mounted horizontally or vertically. Ensure the mounting feet are firmly attached to a stable surface to minimize vibration and noise.
Слика: Страна view of the Carbest 12V water pump, highlighting the four integrated mounting feet designed for secure installation.
3.3 Приклучоци за водовод
Connect the inlet and outlet pipes to the pump. For optimal operation, use pipes with an inner diameter of 12 mm or more. Ensure all connections are tight to prevent leaks.
- Влез: Connect the water supply line to the inlet port. The pump includes a pre-filter that should be installed on the inlet side to protect the pump from debris.
- Излез: Connect the discharge line to the outlet port.
Image: The Carbest 12V water pump, showing the integrated pre-filter on the inlet side and the red and black wires for electrical connection.
Слика: Детална view of the transparent pre-filter assembly, showing the mesh screen inside, which prevents debris from entering the pump.
Image: Bottom perspective of the Carbest water pump, illustrating the threaded inlet and outlet ports for plumbing connections.
3.4 Електрични врски
Connect the pump to a 12V DC power source. The red wire is for the positive (+) terminal, and the black wire is for the negative (-) terminal. Ensure correct polarity. It is recommended to install an inline fuse appropriate for the pump's rated current (7.5A) to protect the electrical circuit.
4. Операција
4.1 Грундирање на пумпата
Before initial operation, ensure the pump is primed. Open a faucet or valve on the discharge side to allow air to escape. Turn on the power to the pump. The pump will begin to draw water and expel air. Once a steady flow of water is achieved, the pump is primed. Close the faucet/valve, and the pump will shut off automatically when the cut-off pressure is reached.
4.2 Автоматско работење
The Carbest 12V water pump is designed for automatic operation. It will turn on when a demand for water is detected (e.g., opening a faucet) and turn off when the demand ceases and the system pressure reaches the cut-off point (2.8 bar).
4.3 Проток
The pump provides a flow rate of 10 liters per minute. Actual flow may vary depending on system pressure, pipe diameter, and elevation.
5. Одржување
5.1 Чистење на претходниот филтер
Regularly inspect and clean the pre-filter to ensure optimal pump performance and prevent damage from debris. To clean:
- Исклучете го напојувањето на пумпата.
- Unscrew the transparent housing of the pre-filter.
- Отстранете ја мрежестата мрежа и исплакнете ја темелно под чиста вода.
- Reassemble the pre-filter, ensuring the O-ring is properly seated to prevent leaks.
- Reconnect power and check for leaks.
Слика: Крупен план view of the transparent pre-filter, indicating the component that requires regular cleaning to maintain pump efficiency.
5.2 Зимување
If the pump will be exposed to freezing temperatures, it must be drained completely to prevent damage. Disconnect the inlet and outlet lines and allow all water to drain from the pump. Store in a dry, frost-free environment.
6 Смена на проблеми
| Проблем | Можна причина | Решение |
|---|---|---|
| Пумпата не се вклучува. | No power; Blown fuse; Loose wiring; Motor fault. | Check power supply; Replace fuse; Secure connections; Contact support. |
| Pump runs but no water flows. | Air in system (not primed); Clogged inlet/filter; Low water supply; Leaks in suction line. | Prime the pump; Clean pre-filter; Check water source; Inspect and seal suction lines. |
| Низок проток или притисок. | Clogged filter; Partially closed valve; Small pipe diameter; Air in system. | Clean pre-filter; Open all valves; Ensure 12mm+ pipe diameter; Re-prime pump. |
| Пумпата често се вклучува и исклучува. | Small leak in system; Pressure switch malfunction; Accumulator tank issue (if applicable). | Check for leaks in plumbing; Contact support for pressure switch or accumulator issues. |
| Прекумерна бучава или вибрации. | Loose mounting; Debris in pump; Air in system. | Secure mounting feet; Clean pump (if accessible); Prime the pump. |
7. Технички спецификации
| Карактеристика | Детал |
|---|---|
| Број на модел | 145773197 |
| Бренд | Карбест |
| Оценето волtage | 12V DC |
| Оценета струја | 7.5 А |
| Стапка на проток | 10 литри во минута |
| Cut-off Pressure | 2.8 бари |
| Систем на пумпа | 3-Compartment Membrane |
| Recommended Pipe Inner Diameter | 12 mm или повеќе |
| Димензии (Д x Ш x В) | 20.3 x 13 x 12.3 cm |
| Тежина | 2.04 килограми |
| Материјал | Пластика, не'рѓосувачки челик |
8. Информации за гаранцијата
Carbest products are manufactured to high-quality standards. For specific warranty terms and conditions, please refer to the warranty card included with your purchase or contact your retailer. The warranty typically covers manufacturing defects under normal use conditions.
Please note: Damage caused by improper installation, misuse, neglect, freezing, or unauthorized modifications is not covered under warranty.
9. Поддршка за корисници
For technical assistance, spare parts, or warranty claims, please contact your authorized Carbest dealer or the point of purchase. When contacting support, please have your product model number (145773197) and purchase date available.
You may also visit the official Carbest webстраница за дополнителни ресурси и информации за контакт.
