Paulmann 94453 Capea LED надворешна ѕидна светилка Lamp со Упатство за детектор на движење

Вовед

Thank you for choosing the Paulmann 94453 Capea LED Outdoor Wall Lamp. This manual provides essential information for the safe installation, operation, and maintenance of your new outdoor lighting fixture. Please read these instructions carefully before installation and retain them for future reference.

Image: The Paulmann Capea LED Outdoor Wall Lamp, showing the product itself and its retail packaging. The lamp is black, with a conical shade and an integrated motion sensor at the base.

Важни безбедносни инструкции

• Електрична безбедност: Installation must be performed by a qualified electrician in accordance with local wiring regulations. Always switch off the main power supply before installation, maintenance, or repair.
• Употреба на отворено: This product is designed for outdoor use (IP44 rated). Ensure all connections are properly sealed to prevent water ingress.
• Монтирање: Mount the fixture securely on a stable surface. Do not install on flammable surfaces.
• Извор на светлина: The LED light source is integrated and not replaceable by the user. Do not attempt to open or modify the light source compartment.
• Температура: Не покривајте го lamp with insulating material. Ensure adequate air circulation around the fixture.

Содржина на пакетот

Проверете дали сите компоненти се присутни пред да започнете со инсталацијата:

• 1x Paulmann Capea LED Outdoor Wall Lamp (Модел 94453)
• Инструкции за склопување
• Монтажни материјали (завртки, ѕидни приклучоци) - (Assumed, as typical for wall lamps)

Технички спецификации

Image: Technical drawing showing the dimensions of the Paulmann Capea LED Outdoor Wall Lamp: 153mm width, 165mm height, and 96mm depth.

Водич за инсталација

Пред да започнете: Ensure the main power supply to the installation area is switched off at the circuit breaker. Use appropriate tools and safety equipment.

1. Подгответе ја локацијата за монтирање: Choose a suitable wall location for the lamp, ensuring it is a stable surface and allows for proper wiring. Mark the drilling points for the mounting bracket.
2. Дупчете дупки: Издупчете дупки на означените точки и вметнете соодветни ѕидни приклучоци (доколку е потребно).
3. Држач за монтирање: Прицврстете го држачот за монтирање на ѕидот со помош на приложените завртки.
4. Жици: Connect the electrical wires from your mains supply to the terminal block inside the lamp fixture. Ensure correct polarity (Live, Neutral, Earth) and secure all connections tightly. Refer to local electrical codes.
5. Прикачи Лamp: Внимателно прикачете го лamp fixture to the mounting bracket, ensuring no wires are pinched. Secure the lamp на место.
6. Вратете ја моќноста: Откако ќе заврши инсталацијата и сите врски ќе бидат безбедни, вратете го напојувањето на главниот прекинувач.

Image: The Paulmann Capea LED Outdoor Wall Lamp shown with its packaging, which illustrates basic installation steps and features like the motion sensor and IP44 rating.

Упатства за работа

The Paulmann Capea LED Outdoor Wall Lamp Има вграден сензор за движење за автоматско работење.

Поставки за сензор за движење

The motion sensor can be adjusted to suit your specific needs. Typically, there are controls for:

• Агол на откривање: Approximately 90 degrees.
• Опсег на откривање: 2-8 метри.
• Чувствителност на светлина (LUX): Determines the ambient light level at which the sensor activates the lamp.
  • ON < 20 Lux: Л.amp will turn on when motion is detected and the ambient light is below 20 Lux (dark conditions).
  • OFF > 20 Lux: Л.amp will remain off when the ambient light is above 20 Lux (daylight conditions).
• ВКЛУЧЕНО време: Sets the duration the light remains on after motion is detected. Adjustable from approximately 5 seconds to 5 minutes.

Adjust these settings using the small dials or switches located on the motion sensor unit, usually found at the bottom of the lamp. Use a small screwdriver if necessary.

Image: A diagram illustrating the motion sensor's detection angle (90 degrees), range (2-8 meters), and light sensitivity settings (On < 20 Lux / Off > 20 Lux), along with the adjustable time duration (5 seconds - 5 minutes).

Слика: Крупен план view of the integrated motion sensor located at the base of the Paulmann Capea LED Outdoor Wall Lamp, showing its spherical lens.

Одржување

• Чистење: Исклучете го напојувањето пред чистење. Избришете го лamp со мека, гamp крпа. Не користете абразивни средства за чистење или растворувачи, бидејќи тие можат да ја оштетат завршната обработка или електричните компоненти.
• Извор на светлина: The LED light source is integrated and designed for long-term use (30,000 hours). It is not user-replaceable. If the LED fails, the entire fixture typically needs replacement.
• Инспекција: Периодично проверувајте го лamp for any signs of damage, loose connections, or wear. Address any issues promptly.

Решавање проблеми

Гаранција и поддршка за корисници

Paulmann products are manufactured to high quality standards. This product comes with a 5-year guarantee, as indicated on the packaging. For warranty claims, technical assistance, or further inquiries, please contact your retailer or Paulmann customer support directly. Keep your proof of purchase for warranty purposes.

For more information, visit the official Paulmann webсајт: www.paulmann.com

Информации за отстранување

This product contains electronic components and an integrated LED light source. Do not dispose of it with general household waste. Please take it to a designated collection point for electrical and electronic equipment recycling in accordance with local regulations. Proper disposal helps prevent potential negative consequences for the environment and human health.