FLYLINKTECH BD10 6000A 12V Car Jump Starter and Power Bank User Manual

1. Вовед

Thank you for choosing the FLYLINKTECH BD10 6000A 12V Car Jump Starter and Power Bank. This device is designed to provide emergency jump-starting for vehicles and serve as a portable power bank for various electronic devices. Please read this manual thoroughly before use to ensure safe and optimal operation.

Image 1.1: The FLYLINKTECH BD10 Jump Starter unit with its smart battery clamps.

2. Информации за безбедност

Always observe the following safety precautions to prevent injury or damage to the device or vehicle:

• Не обидувајте се да стартувате замрзната батерија со електричен чек.
• Обезбедете правилен поларитет на поврзувањето (црвено кл.)amp до позитивен, црно clamp to negative). Reverse polarity can cause damage.
• Do not allow the smart clamps to touch each other when connected to the jump starter.
• Чувајте го уредот подалеку од деца.
• Do not expose the device to extreme temperatures (above 60°C / 140°F or below -20°C / -4°F) or direct sunlight for extended periods.
• Не расклопувајте или менувајте го уредот.
• Use only the provided smart clamps and charging cables.
• If the device becomes excessively hot during use, disconnect it immediately.

Image 2.1: The jump starter incorporates multiple safety features such as spark-proof, reverse polarity, overvoltage, short circuit, overload, and high-temperature protection.

3. Содржина на пакетот

Проверете дали сите артикли се присутни во пакувањето:

• FLYLINKTECH BD10 Jump Starter Unit
• Паметна батерија Clamps
• Кабел USB-C на USB-C
• Кабел USB-A до USB-C
• 12V DC Car Charger Adapter
• Упатство за употреба
• Случај за складирање

Image 3.1: The complete package includes the jump starter, smart clamps, various cables, user manual, and a protective storage case.

4. Поставување и полнење

4.1 Почетно полнење

Before first use, fully charge the jump starter. The device features a 26800mAh battery capacity.

• Connect the provided USB-C cable to the jump starter's USB-C input port.
• Connect the other end of the cable to a compatible USB wall charger (not included). For fastest charging, use a PD 45W charger.
• The LED screen will display the charging status and battery percentage.

4.2 Времиња на полнење

Note: A 45W wall charger is not included in the package.

Image 4.1: The device supports PD 45W fast charging, significantly reducing recharge time when using a compatible charger.

5. Упатства за работа

5.1 Скок Стартување на возило

The FLYLINKTECH BD10 is capable of jump-starting all gas engines and diesel engines up to 12.0L.

1. Обезбедете доволно полнење: Check the jump starter's LED screen to ensure it has at least 50% charge.
2. Поврзете го Smart Clamps: Вметнете го синиот приклучок на паметниот кл.amps into the jump starter's 12V output port. Ensure a firm connection.
3. Поврзување со автомобилска батерија:
   • Прикачете го црвено (+) clamp to the vehicle's positive battery terminal.
   • Прикачете го црно (-) clamp to the vehicle's negative battery terminal.
4. Проверете го индикаторот: Паметниот clamp indicator light should turn solid green, indicating a correct connection. If it flashes or shows red, check connections and battery status.
5. Press BOOST (if needed): If the vehicle battery is extremely low or completely dead, press the 'BOOST' button on the jump starter. Wait for the indicator light on the smart clamps to turn solid green.
6. Стартување на возилото: Attempt to start your vehicle. If it doesn't start on the first try, wait 30 seconds before trying again. Do not attempt more than 3 consecutive starts.
7. Отстранете го Clamps: Откако возилото ќе се запали, веднаш извадете го паметниот клапamps from the car battery, then disconnect them from the jump starter.

Image 5.1: The jump starter connected to a car battery, ready for operation. It supports 6000A peak current, 12V output, and is suitable for a wide range of engines.

Image 5.2: Visual guide illustrating the four steps to jump-start a vehicle: connect the plug, attach clamps, press boost, and start the engine.

5.2 Функција на енергетска банка

The BD10 can charge multiple electronic devices via its USB-A and USB-C ports.

• USB1 излез: До 18W (макс.)
• USB2 излез: До 18W (макс.)
• USB-C излез: До 45 W (PD)

Connect your device using the appropriate USB cable to the desired output port. The LED screen will show 'OUT' and the wattage being drawn.

Image 5.3: The jump starter functioning as a power bank, simultaneously charging a smartphone and a tablet via its USB ports.

5.3 LED светилка

The built-in LED flashlight offers three modes: constant light, SOS signal, and strobe light.

• Press and hold the flashlight button to turn on the constant light.
• Press the button again to cycle through SOS and strobe modes.
• Притиснете и задржете повторно за да се исклучи.

Image 5.4: The integrated LED flashlight provides illumination, an SOS signal, and a strobe function for emergency situations.

5.4 Informative LED Screen

The 6.0-inch LED screen provides real-time information about the device's status:

• Ниво на батерија: Го прикажува преостанатиот процент на батеријатаtage.
• IN/OUT Indicator: Shows whether the device is charging (IN) or discharging (OUT).
• Ватtagд Приказ: Indicates the power (W) being drawn or supplied.
• Предупредувања за грешка: Displays specific error codes or symbols if an issue occurs.

Image 5.5: The 6.0-inch LED screen provides clear information on battery percentage, input/output status, and power consumption.

6. Одржување

• Редовно полнење: За да го продолжите животниот век на батеријата, полнете го стартерот на секои 3-6 месеци, дури и ако не е во употреба.
• Складирање: Store the device in its protective case in a cool, dry place, away from direct sunlight and moisture.
• Чистење: Избришете го уредот со мека, сува крпа. Не користете груби хемикалии или абразивни материјали.
• Clamp Грижа: Обезбедете го паметниот клampсе чисти и без корозија пред и по секоја употреба.

7 Смена на проблеми

The device features multiple alarm situations indicated by audible signals and screen displays:

• Низок волуменtagд Заштита: Audible signal "3". Recharge the device.
• Надворешен волtage Exceeds Vehicle Voltage: Audible signal "4". Check vehicle battery voltage.
• Заштита од краток спој: Audible signal "5". Check clamp connections for short circuits.
• Safety Mode Activated: Audible signal "6". Device has entered safety mode due to an issue.
• Заштита од прекумерна струја: Audible signal "7". Reduce load or check connections.
• Аларм за висока/ниска температура: Audible signal "8". Allow device to return to operating temperature range (-20°C to 60°C).
• Reverse Connection: Audible signal "9". Correct the clamp поларитет

Слика 7.1: Готовоview of the device's multi-alarm system, indicating various protection states with unique audible signals.

Доколку проблемите продолжат откако ќе ги следите овие чекори, ве молиме контактирајте ја корисничката поддршка.

8. Спецификации

Image 8.1: The device is designed to operate reliably in extreme climates, from -20°C (-4°F) to 60°C (140°F).

9. Гаранција и поддршка

FLYLINKTECH is committed to providing high-quality products. For any questions, technical assistance, or warranty claims, please refer to the contact information provided with your purchase or visit the official FLYLINKTECH webстраница. Ве молиме зачувајте го доказот за купување за целите на гаранцијата.