Упатство за употреба на безжична метеоролошка станица TFA Dostmann Clear 35.1168.02
Model: 35.1168.02 | Brand: TFA Dostmann
1. Вовед
This manual provides detailed instructions for the setup, operation, and maintenance of your TFA Dostmann Clear 35.1168.02 Wireless Weather Station. Please read this manual thoroughly before using the device to ensure correct operation and to prevent damage.
The weather station monitors indoor and outdoor temperature and humidity, and provides a weather forecast based on atmospheric pressure changes.
2. Информации за безбедност
- Чувајте го уредот и батериите подалеку од дофат на деца.
- Не го изложувајте уредот на екстремни температури, вибрации или удари.
- Избегнувајте директна сончева светлина и влага.
- Не го потопувајте уредот во вода.
- Use only specified batteries. Ensure correct polarity.
- Replace all batteries simultaneously.
- Dispose of depleted batteries and the device according to local regulations.
- The outdoor sensor should be placed in a sheltered location, protected from direct precipitation.
3. Содржина на пакетот
- Base Station (Weather Station)
- Thermo-Hygrometer Outdoor Sensor (Model: 30.3256.02)
- Упатство за употреба
Note: 4 x 1.5V AAA batteries (2 for base station, 2 for outdoor sensor) are required and not included.
4. Производот завршиview
Figure 1: TFA Dostmann Clear 35.1168.02 Wireless Weather Station (Base Unit and Outdoor Sensor).
This image displays the main weather station unit on the right, showing its digital display with atmospheric pressure, weather icons, outdoor temperature and humidity, and indoor temperature and humidity. To the left is the compact outdoor sensor, also displaying temperature and humidity.
4.1 Base Station Display Elements
Figure 2: Close-up of the Weather Station Display.
The display shows: atmospheric pressure (hPa), weather forecast icons (sunny, partly cloudy, cloudy, rainy), outdoor channel indicator (CH 1 OUT), outdoor temperature (°C/°F) and humidity (%), and indoor temperature (°C/°F) and humidity (%).
- Атмосферски притисок: Displayed in hPa, with trend arrows.
- Икони за временска прогноза: 4 symbols (sunny, partly cloudy, cloudy, rainy) based on pressure changes.
- Надворешна температура и влажност: From the wireless sensor.
- Внатрешна температура и влажност: Measured by the base station.
- Индикатор за канали: Shows which outdoor sensor channel is currently displayed (up to 3 sensors supported).
4.2 Base Station Control Buttons (Rear)
Figure 3: Rear of the Base Station showing control buttons and battery compartment.
The rear panel features four control buttons: DOWN, UP, CHANNEL, and SET. These buttons are used for navigating settings, adjusting values, and switching between outdoor sensor channels.
- ДОЛ: Ги намалува вредностите, се движи низ менијата.
- Горе: Ги зголемува вредностите, се движи низ менијата.
- КАНАЛ: Switches between outdoor sensor channels (if multiple sensors are paired).
- СЕТ: Влегува во режим на поставки, ги потврдува изборите.
5. Поставување
5.1 Инсталација на батерија
- Надворешен сензор: Open the battery compartment on the back of the outdoor sensor. Insert 2 x 1.5V AAA batteries, observing correct polarity (+/-). Close the compartment.
- Базна станица: Open the battery compartment on the back of the base station. Insert 2 x 1.5V AAA batteries, observing correct polarity (+/-). Close the compartment.
- The base station will emit a short beep and all LCD segments will light up briefly. It will then display indoor temperature and humidity. The outdoor sensor data will appear shortly after.
5.2 Спарување на сензори
The base station will automatically attempt to connect to the outdoor sensor upon battery insertion. Ensure the sensor is within range (max. 100m in open air). If connection is not established, press the "CHANNEL" button on the base station to initiate a manual search.
The station supports up to three outdoor sensors. To add additional sensors, repeat the battery installation process for each new sensor. Use the "CHANNEL" button to cycle through and display data from different sensors.
5.3 Initial Settings (Atmospheric Pressure)
The atmospheric pressure needs to be set during initial setup for accurate weather forecasting. Consult a local weather service or online source for the current atmospheric pressure in your area.
- Press and hold the "SET" button until the atmospheric pressure value flashes.
- Use the "UP" or "DOWN" buttons to adjust the value to your local atmospheric pressure.
- Press "SET" again to confirm and exit the setting mode.
5.4 Поставување
- Базна станица: Place the base station indoors on a flat surface or mount it on a wall. Avoid placing it near heat sources, direct sunlight, or areas with high electromagnetic interference.
- Надворешен сензор: Position the outdoor sensor in a sheltered location, protected from direct rain and snow. Ensure good air circulation around the sensor. Avoid direct sunlight to prevent inaccurate temperature readings. The maximum range is 100m (open field).
6. Ракување со метеоролошката станица
6.1 Displaying Temperature and Humidity
The base station continuously displays indoor temperature and humidity, along with the selected outdoor sensor's temperature and humidity.
6.2 Префрлување на температурни единици (°C/°F)
To switch between Celsius and Fahrenheit, briefly press the "UP" button outside of setting mode.
6.3 Временска прогноза
The weather station provides a forecast for the next 12-24 hours using four weather icons: sunny, partly cloudy, cloudy, and rainy. These forecasts are based on changes in atmospheric pressure. The accuracy of the forecast improves after the initial atmospheric pressure setting has been stable for several hours.
6.4 Atmospheric Pressure Trend
Arrows next to the atmospheric pressure display indicate whether the pressure has risen, fallen, or remained stable over the last hour. This helps in understanding short-term weather trends.
7. Одржување
7.1 Чистење
Исчистете го уредот со мека, гamp крпа. Не користете абразивни средства за чистење или растворувачи. Осигурајте се дека влагата не влегува во уредот.
7.2 Замена на батеријата
Replace batteries when the low battery indicator appears on the display. Always replace all batteries in a unit (base station or sensor) simultaneously to ensure optimal performance. Dispose of old batteries responsibly.
8 Смена на проблеми
| Проблем | Можна причина | Решение |
|---|---|---|
| No outdoor temperature/humidity display. |
|
|
| Неточна временска прогноза. |
|
|
| Екранот е затемнет или празен. |
|
|
9. Спецификации
| Карактеристика | Детал |
|---|---|
| Број на модел | 35.1168.02 |
| Опсег на надворешна температура | -20 ° C до +60 ° C (-4 ° F до +140 ° F) |
| Опсег на внатрешна температура | -10 °C до +50 °C (+14 °F до +122 °F) |
| Опсег на влажност во затворен простор | Релативна влажност од 20% до 95%. |
| Материјал | Пластика |
| Maximum Range (Outdoor Sensor) | 100 m (отворен терен) |
| Included Transmitter Model | 30.3256.02 (Max. 3 transmitters supported) |
| Фреквенција на пренос | 433 MHz |
| Опции за монтирање | Стоење на маса или закачување на ѕид |
| Power Supply (Batteries) | Base Station: 2 x 1.5V AAA (not included) Outdoor Sensor: 2 x 1.5V AAA (not included) |
| Димензии (Д x Ш x В) | 94 x 20 (58) x 105 (101) mm |
| Тежина | 109 гр |
10. Гаранција и поддршка
TFA Dostmann products are manufactured with quality and precision. For warranty information and technical support, please refer to the official TFA Dostmann webлокација или контактирајте го вашиот локален дистрибутер. Чувајте ја сметката како доказ за купување.
Spare parts availability: 1 Year.
Производител: TFA Dostmann
Земја на потекло: Кина
