PetJoy 3 Dog Shock Collar User Manual

Вовед

The PetJoy 3 Dog Shock Collar system is designed to assist in training up to three dogs simultaneously or individually. It features both automatic bark detection and remote-controlled training modes, including beep, vibration, and static stimulation. This manual provides comprehensive instructions for setup, operation, maintenance, and troubleshooting to ensure effective and safe use of the device.

Информации за безбедност

• This device is intended for training purposes only. Do not use it as a punishment tool.
• Not suitable for aggressive dogs. Consult a professional dog trainer if your dog exhibits aggressive behavior.
• Do not leave the collar on your dog for more than 12 hours per day to prevent skin irritation.
• Regularly check your dog's neck for signs of irritation or sores. If irritation occurs, discontinue use until the skin heals.
• Да се ​​чува подалеку од дофат на деца.
• Ensure proper fit; the collar should be snug but not overly tight.
• Always start with the lowest stimulation level and gradually increase as needed.

Содржина на пакетот

Ве молиме проверете дали сите артикли наведени подолу се вклучени во вашиот пакет:

• 3 x ремени за јака
• 1 x Clicker
• 3 x Shock Collar Receivers
• 1 x далечински управувач
• 2 x Charging Wires
• 1 x решетка

Image: All components included in the PetJoy 3 Dog Shock Collar package.

Производот завршиview

Familiarize yourself with the main components of your PetJoy training system.

Image: The PetJoy 3 Dog Shock Collar system, including three receiver collars and the remote control.

Далечински управувач

• Екран за прикажување: Shows battery level, selected dog channel, mode, and intensity level.
• Копчиња за режим: Separate buttons for Beep, Vibration, and Static Stimulation.
• +/- Копчиња: Adjust intensity levels for Vibration and Static Stimulation.
• Копче за канал: Switch between dog channels (1, 2, 3) or control all simultaneously.
• Копче за вклучување: Turns the remote on/off and activates/deactivates Auto Mode on the receiver.

Јака за приемник

• Контакт точки: Deliver static stimulation. Ensure proper contact with the dog's skin.
• Auto Mode Sensor Hole: Detects barking for automatic correction.
• Порта за полнење: For recharging the receiver battery.
• LED индикатор: Shows power status, charging status, and mode activation.

Водич за поставување

1. Полнење на уредите

Before first use, fully charge the remote control and all receiver collars. Use the provided charging cables.

• Connect the charging cable to the charging port on the remote and receivers.
• Plug the USB end into a USB power adapter (not included), computer, or power bank.
• The LED indicator on the receiver will show charging status (e.g., red while charging, green when full). The remote display will show battery icon filling up.
• Charging typically takes 2-3 hours. A full charge provides approximately 90 days of work time for the remote and 30 days for receivers.

Image: Charging the remote and receiver collars.

2. Pairing the Remote and Collars

Each receiver collar needs to be paired with the remote control.

1. Вклучете го далечинскиот управувач.
2. Select the desired channel (1, 2, or 3) for the collar you are pairing using the Channel button.
3. With the receiver collar turned off, press and hold its power button until the LED indicator flashes rapidly.
4. While the receiver LED is flashing, press any mode button (Beep, Vibration, or Shock) on the remote control.
5. If pairing is successful, the receiver LED will stop flashing and remain solid, and the remote will confirm the connection.
6. Repeat for additional collars, selecting a different channel for each.

3. Поставување на јаката

Proper fit is crucial for effective and safe operation.

• Position the receiver on the underside of your dog's neck, directly below the chin.
• Ensure the contact points touch your dog's skin. You may need to trim long fur for better contact.
• Прилагодете го ременот така што е тесен, дозволувајќи само еден прст удобно да се смести помеѓу ременот и вратот на вашето куче.
• The collar should not be too loose, as this can cause inconsistent stimulation and rubbing. It should not be too tight, as this can restrict breathing or cause discomfort.

Упатства за работа

Режими на обука

The PetJoy collar offers four training modes:

• Бип режим: Delivers an audible tone. This is often used as a warning or positive reinforcement signal.
• Режим на вибрации: Delivers a non-harmful vibration. Intensity is adjustable from 1-100 levels.
• Режим на шок: Delivers a static stimulation. Intensity is adjustable from 1-100 levels. Always start at the lowest level and increase gradually.
• Автоматски режим: The collar automatically detects and corrects barking. It has 5 sensitivity levels and a sequence of corrections (Beep, then Vibration, then Static Stimulation) if barking persists.

Image: Detailed activation sequences for the automatic bark detection mode.

Image: The collar's ability to operate in Auto Mode independently.

Controlling Multiple Dogs

The remote allows you to control up to three collars individually or all at once.

• Користете го Копче за канал on the remote to switch between Dog 1, Dog 2, Dog 3, or a universal channel to control all paired collars simultaneously.
• Ensure each collar is paired to a unique channel for individual control.

Image: Controlling multiple dogs with the remote.

Adjusting Sensitivity (Auto Mode)

To adjust the sensitivity of the automatic bark detection mode:

• With the receiver collar turned on, quickly press its power button 3 times.
• The LED indicator will flash a certain number of times to indicate the current sensitivity level (1-5 flashes).
• Continue pressing the power button 3 times in quick succession to cycle through the 5 sensitivity levels. Level 1 is the least sensitive, and Level 5 is the most sensitive.
• Select a sensitivity level appropriate for your dog's barking habits and environment.

Activating/Deactivating Auto Mode

You can turn the automatic bark detection mode on or off via the remote control.

• Ensure the remote and receiver are paired and within range.
• Press and hold the remote control's power button.
• You will hear the receiver beep once to confirm Auto Mode is turned ON, or twice to confirm it is turned OFF.

Одржување

Чистење

• Редовно чистете го прстенот на приемникот и контактните точки со рекламнаamp крпа.
• Ensure the contact points are free of dirt, debris, or corrosion.
• Не користете груби хемикалии или абразивни средства за чистење.

Нега на батерии

• Charge the devices fully before long periods of inactivity.
• Да се ​​чува на ладно и суво место.
• Избегнувајте екстремни температури, кои можат да влијаат на животниот век на батеријата.

Хидроизолација

The receiver collar is IPX7 waterproof, meaning it can withstand immersion in water up to 1 meter for 30 minutes. This makes it suitable for use in rainy conditions or during swimming.

Image: The collar's IPX7 waterproof capability.

Решавање проблеми

Спецификации

Гаранција и поддршка

The PetJoy 3 Dog Shock Collar comes with a 2-годишна гаранција од датумот на купување, опфаќајќи ги производствените дефекти и дефектите при нормална употреба.

For detailed warranty information, technical support, or any inquiries, please refer to the official user guide or contact PetJoy customer service.

Официјално упатство за корисникот (PDF): Преземете овде

PetJoy Brand Store: Посетете ја продавницата